"Zero" Or "Tare" Function - CONTINENTAL EDISON CEKT5B2 Guide D'utilisation

TO REPLACE BATTERY
2 PCS AAA batteries (not included)
1.Open battery case cover on the back of scale.
2.Take out the used batteries.
3.Install new battery by putting one side of the
battery and then pressing down the other side.
Please take note to the polarity.
TO OPERATE SCALE
1. Please put the scale on a hard and flat
2. Place bowl (if used) on the scale before
3. Press and release ON/OFF button to turn
4. Wait until display prompts to '0' before
TO CONVERT WEIGHT UNITS
If the scale is with both measuring system of
Metric (kilograms,grams) and Imperial (pounds,
ounces), you can press UNIT to convert
between two systems during the course of
weighing.
5
surface.
turning on the unit.
on the unit.
starting weighing.

"ZERO" or "TARE" function

To weigh different loads consecutively without removing loads from the scale.
Put first load on the scale, get weight reading. Press Z/T button to reset
the LCD reading to '0' before adding next load. You can repeat this operation.
Condition 1:"ZERO" function
When total sum of all loads on scale
≤ 4% of scale's max capacity.
(4%=80g when capacity is 2kg;
200g when capacity is 5kg)
LCD will show '0g' each time Z/T is pressed.
Icon '0' will show on left lower corner of LCD,
indicating 'ZERO' function is active.
Max.weight capacity remains unchanged.
Condition 2: "TARE" function
When total sum of all loads on scale
> 4% of scale's max capacity.
(4%=80g when capacity is 2kg;
200g when capacity is 5kg)
LCD will show '0g' each time Z/T is pressed.
Icon 'TARE' will show on left upper corner of
LCD, indicating 'TARE' function is active .
Max.weight capacity is reduced by total weight
of all loads.
Under this condition:
By pressing Z/T, you can see the total weight
of all loads on the scale. If you want to weigh
more loads, just press Z/T to reset LCD
reading to '0' again.
6