Handle And Erection; Preparation And Power Supply - CombiSteel 7487.0160 Mode D'emploi

Handle and erection

Handle with care
Unplug the wall socket first.
Never tilt it over 45 degree during handling.
Sufficient space
The distance from both sides and back of refrigerator
to wall or other objects must be more than 10cm.
The refrigeration capability might be decreased if its
surround space is too small to circulate air.
Far from heat source
Never place the refrigerator directly under the
sunshine. Never locate it nearby any heat source or
heater to prevent it from reducing refrigeration
capability.
No hole making
Never make a hole on the refrigerator. Never install
other matter on the refrigerator.

Preparation and power supply

Exclusive power socket
Normally, the power supply should be 220-240V
single phase AC with exclusive single phase three pin
receptacle (250V, 10A) and fuse (6A). The power
receptacle must have a reliable earth connection.
Protect cables
Never break or damage the cables otherwise current
leakage and fire may occur.
Dry place
Always locate the refrigerator at a dry place.
Well ventilation
Always locate the refrigerator at a place with fine
ventilation. For the first time of use, wait for 2 hours
after handling and then plug the wall socket and start
it.
No heavy load
Never put any heavy load on the top of the
refrigerator.
Stable location
Unpack and locate the refrigerator on a flat and solid
place.
No share on socket
Never let the refrigerator share the common socket
with other appliances, otherwise the cable becomes
hot and fire may occur.
No water flushing
Never give the refrigerator surface a flush otherwise
current leakage may occur.
www.combisteel.com
4