DURAVIT 2x3 700023 Notice De Montage page 5

Important information
Regarding the mounting instructions
These mounting instructions comes as part of the Duravit
bathtub and should be read carefully prior to installation.
Explanation of key words and symbols
NOTE!
In the case of potential damage to property
Link to installation information in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and tightness
Target group and qualification
The bathtub must only be installed by trained plumbing
engineers.
Note!
Local installation regulations and any country­specific
standards must be observed at all times.
Installation information
3
Installing the cable-driven waste and overflow
The connection hose #790159/ #790166 is
recommended for installing a cable­driven waste
and overflow with a bathtub spout and base inlet.
24
Providing for an inspection hatch (Diagram 24)
• Area: drain and overflow fittings
• Dimensions of the inspection hatch
for drain fittings: min. 20 x 20 cm
31
Closing inspection hatch (Diagram 31)
• Sealed to avoid spray water
• Only to be opened with a tool
BA_M_Einbau_Fliesen_Rechteck/16.12.6
7