Technical Data - HERKULES FMR 800 Mode D'emploi

Anleitung FMR 800 Herkules
GB
Proper usage
This machine is designed to mix liquid and powdery
building materials such as paint, mortar, adhesive,
plaster and similar substances. It must be fitted with
the correct mixing tool for the consistency and
quantity of material in question in order to achieve
the required mixing effect. The machine can also be
used as a drill.
Description (Fig. 1)
1 On/Off switch
2 Clockwise/Anti-clockwise switch
3 Chuck
4 Additional handle
5 Chuck key
6 Removal wedge
7 Locking knob

Technical data

Mains voltage 230 V ~ 50 Hz
Power consumption
Idling speed 0 - 300 rpm
Chuck clamping range
Drilling capacity Max. 23 mm
Drill spindle cone
LPA noise level
LWA noise level
Vibration a w
Safety insulated
Weight
Important notes
Read the operating manual carefully and follow the
instructions therein. Make yourself familiar with the
machine, how to use it correctly and the safety
instructions.
Safety instructions
Important! When using electric tools the following
basic safety measures are to be taken to protect
yourself from electric shocks and the risks of
suffering injuries and burns. Read and follow these
instructions before you use the machine. Keep these
instructions in a safe place. The attached booklet
contains further safety instructions.
6
20.11.2003 16:04 Uhr
● Do not use the machine in an atmosphere where
there is a risk of explosion. Do not mix any
solvents or substances that contain solvents with a
flash point of below 21°C.
● Do not place any cables around any parts of your
body.
● Only use extension cables that are suitable for the
area in which you are working.
● Only start and stop the machine in the mixing
vessel. Ensure that the mixing vessel is placed on
a firm, secure base.
● Do not reach into the mixing vessel with your
hands or any other objects during the mixing
process.
● We recommend that you wear gloves and safety
goggles when working with the mixing machine.
● You must wear close-fitting clothing.
● Always use the additional handle.
● Always expect reaction torque.
Before starting the machine (Abb. 2)
Before making the connection, ensure that the data
800 W
on the model plate are identical with the mains data.
Fit the additional handle (4) to the machine. Before
installing the chuck (3) using the MK shaft (8), check
3 - 16 mm
that both parts are clean. Push the MK shaft (8)
forcefully into the cone of the chuck. Then also push
MK 2
the cone into the drill spindle.
83.1 dB(A)
Starting the machine
96.1 dB(A)
<2.5 m/s
2
Switching on/off
II /
Select the speed by pushing the switch (1) more or
4.6 kg
less forcefully.
Switch on: Push the switch (1)
Continuous operation: Lock the switch (1) with
the locking knob (7)
Switch off: Press the switch (1)
briefly
You can select the direction of rotation using the
switch (2).
Working with the paint and mortar
mixer
The additional handle must be fitted!
Seite 6