Assembling The Device; Working With The Device - physa VP-800 Manuel D'utilisation

Assembling the device:

1. Fit the wheels to the base: 2. Place the stand in the opening of the base:
3. Secure the whole by screwing the metal lock underneath the base.
4. Put the water container bracket onto the stand:
5. Fit the device onto its stand, making sure to align the opening in the stand with the opening in the device, then tighten
the security screw:
6. Disassembling and assembling water container:
To disassemble the water container push the bracket handle downwards then move the bracket to one side and unscrew
the container:
Rev. IV 2016
12 12
7. Assembly of the steam nozzle on the device's arm: unscrew the four screws and remove the housing element as shown
on the pictures:
Slip the steam nozzle on the device arm:
Put the housing back and tighten the four screws.
The device is ready for use - before starting, make sure to fill the water container with water!

Working with the device:

Never switch the device on before having filled the water container (the water should not exceed the MAX level marked
on the container). Make sure that both switches are in off position (OFF). Connect the power cord to the power socket and
turn the device on using the "VAPOR" switch. The heater will start heating and after a few minutes steam will start flowing
from the nozzle. If required, you may now turn the ozone function on (using the "OZONE" switch):
During use, regularly check the water level in the container. It must always be above the minimum level marked on the
container. Before refilling, always switch the device off!
If the water level falls below minimum while the device is running, the device will turn off automatically.
In this case, turn off the device and refill the container to the required level (do not exceed the maximum level) and then
turn the device back on. Using the device without water may damage the heater! Do not add cold water in the hot water
container, it can damage the container.
The device can be used with any kind of water. However, it is recommended to use distilled or boiled water (ideally, the
water should be boiled and left to rest for 12 hours before use).
OZONE – Ozone power switch
VAPOR – Steam power switch
O/lamp – indication lamp (ozone function)
V/lamp – indication lamp (steam function)
Rev. IV 2016
13