Technical Data; Safety Instructions - REV Ritter EMP100SW Mode D'emploi

GB
Operating voltage:
Output:
Protection class:
Switch:
This product may only be installed by a qualified elec-
trician! Turn the electric current off at mains supply fuse
box and secure against being switched on again before
commencing installation! Check the line with a two-pole voltage
tester to verify isolation from power supply!
1. Undo the screws  of the switch plug and remove the top.
2. Connect the plug as shown in the diagram . Wire sleeves must be used
for flexible wires. Connect the yellow/green wire to the marked earth con-
, brown wire to the connection marked L and the blue wire to
nection
the connection marked N. Make sure that the cable strain-relief clamp is
fitted tight.
3. Put the top back in place and tighten the screws.
In accordance with European defaults used electrical and electronics devices
may no more be given to the unsorted waste. The symbol of the waste bin on
wheels refers to the necessity of separate collection. Please help with environ-
mental protection and see to it that this device is given to the for this purpose
designated systems of waste sorting if you do not use it any longer. DIREC-
TIVE 2012/19/EU of the EUROPEAN PARLIAMENT AND OF the COUNCIL
of 4 July 2012 on waste electrical and electronic equipment (WEEE).

Technical Data

250V∼, 50Hz
16A, max. 3680W, 2-pole
IP20, only for use in dry indoor areas
2-pole

Safety Instructions

Connection
WEEE-reference of disposal