Neriox 141051 Mode D'emploi page 3

3
141051
UNIVERSAL PROTRACTOR
Operating instructions
Legend
1. Locking screw
2. Fine adjustment
3. Straightedge clamping screw
4. Panoramic magnifier
5. Main stop
6. Angle scale
Specification
Angle reading: 4 x 90°
Angle resolution: 5' (1/12°)
Properties
Rust-free, hardened and finely ground
Matt chrome-plated measuring scale
Parallax-free Vernier reading
Panoramic magnifier included
Fine adjustment included
Scope of delivery
1 main body with magnifying glass
1 150-mm straightedge
1 200-mm straightedge
1 300-mm straightedge
1 radial stop
Operation
Insert the straightedge in the guide with the groove facing upwards and, after setting the required length or making adjustments, fix in place using the straightedge
clamping screw (3). Adjust the rail with the main stop (5) on an even surface, e.g. granite marking plate or straightening plate. Following adjustment, check whether
"0 degrees" can be read off the scale; readjust if necessary. Fitting of the radial stop for the purpose of measuring internal and external angles of grooves. Loosen the
groove bolt of the radial stop by approx. 16-18 mm, and insert in the intermediate space of the main stop (5). The bolt must be completely inserted and then turned
through 90 degrees. Finally, fix the radial stop in place using the locking screw. Some examples of use are given below.
Repair
If the instrument is defective, please contact our
service centre Servicecenter@brw.ch
Brütsch/Rüegger Werkzeuge AG, Heinrich Stutz-Strasse 20, Postfach, CH-8902 Urdorf, Tel. +41 44 736 63 63, Fax +41 44 736 63 00, www.neriox.tools, sales@brw.ch
Safety-relevant information
• Protect the universal protractor against mechanical damage
Properties
Main body and straightedges of stainless steel
Interchangeable, sliding straightedges
Panoramic magnifier
Matt measuring scale
No-glare reading
Parallax-free Vernier reading
Instructions for care:
A cleaning agent and a soft cloth can be used for cleaning the
surfaces.