Rear Connections - ION iCD02 Guide D'utilisation Simplifié

1. Make sure all items listed on the front of this guide
are included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE
USING THE PRODUCT.
3. Study this setup diagram.
4. Place CDMIX station in an appropriate position for
operation.
5. Make sure all devices are turned off and all faders
and gain knobs are set to "zero"
6. Connect all stereo input sources as indicated in the
diagram.
7. Connect the stereo outputs to power amplifier(s),
tape decks, and/or other audio sources.
8. Plug all devices into AC power.
1. Channel Inputs: Unbalanced RCA jacks for
connecting external sources. The Phono/Line input is
selected using the toggle switch on the front panel.
Turntables, HiFi VCRs, cassette and reel-to-reel tape
decks, DAT machines, CD players, laser discs, tuners,
even synthesizers or other mixing consoles can be
connected using these jacks. NOTE: Plug mono audio
sources into both left and right inputs using a "Y"
cable connector.
2. GND: This screw connector should be used to connect
any turntables or other devices that need to be
grounded.
3. Input Selector Switch: Use this to allow either line
level or phono level equipment to be plugged into
your channel inputs. When Phono input is selected,
your signal is fed directly to the high-quality RIAA
iCD02 QUICK SETUP
9.
10.
11.
More information about this product may be found at

REAR CONNECTIONS

phono pre-amplifiers. Use this position only for
turntables. Line level sources will overload the
sensitive phono pre-amps and will sound very bad, so
always be sure to toggle the line/phono switch over to
line before connection of line sources.
4. Record Output: This RCA output is for connecting a
recording device such as a tape deck or CD recorder.
The level of the record output is based upon pre-
master levels.
5. Master Output (RCA): This output is for connecting
an external monitoring device such as a PA system,
powered monitors, or a home stereo. The level of the
master stereo output signal is controlled by the
master fader.
6. Mic Input: Plug your 1/4" Microphone plug in here.
Switch everything on in the following order.
•
audio input sources (i.e. turntables or CD
players)
•
ICD02
•
last, any amplifiers or output devices
When turning off, always reverse this operation by,
•
turning off amplifiers
•
ICD02
•
last, any input devices
Go to http://www.ion-audio.com
registration.
http://www.ion-audio.com
for product