CasaFan FB-IR Basic Instructions De Montage Et De Service page 8

GB
Positioning the remote control at fans with downrod
sketch 1
IR sensor
1. Place the receiver as shown in sketch 1 and 2 into the mounting bracket. Bring the inf-
rared sensor outside the canopy without damaging the wires.
2. Make the electrical connection to your fan as per wiring diagram on page 7. The handling
of the AC power line should ensure that it can not be damaged or pinched!
If the live to motor (L-motor) and live fan light (L-light) of your ceiling fan are con-
nected combined, they must be separated BEFORE installing your remote control receiver.
3. Install the canopy on the monting bracket.
The pull chain switch of your ceiling fan must be set on highest speed.
After setting the mains supply back on your ceiling fan with the remote control it is ready
to be used.
Positioning the remote control at CasaFan low profi le fans as i.e. FLAT, GLASHAUS FLAT or
OFFICE FAN
Please install the receiver of your remote control as shown schematically in sketch 3.
After the electrical connection has been set up, use the self-adhesive stickers to attach the re-
ceiver onto the ceiling. If this is not possible, i.e. due to a rendering coat, cable straps need to
be used for the mounting plate to assure that the receiver can not crash off the ceiling. Bring the
8
canopy
downrod
receiver
canopy
downrod
sketch 2
infrared receiver eye out-
side the housing without
damaging the wires. The
pull chain switch of
your ceiling fan must be
set on highest speed.
After setting the mains
supply back on your cei-
ling fan with the remote
control it is ready to be
used.