Publicité
Les langues disponibles
Les langues disponibles
3
9
5
4
7
Assemble the remaining parts (9,5,4,7,3). Be careful to align the
main body's key (1) onto the light's (9) keyway. See detail
5
LOCKING
RING
Choose your union (10) and screw it onto the
main body (1) with the locking ring. Connect
or glue, your inlet hose.
Instructions
simultaneously on the remote control. Try the remote and repeat if necessary, always disconnecting power between each try.
Make sure there is no short-circuit.
Remote control
- ON / OFF
- MODES
M
M1: Waving changing colors
M2: Jumping changing colors
M3: Fading out
M4: Waving changing colors + Jumping changing colors (M1& M2)
M5: Gradually changing colors
+
-SPEED: After pushing
-
C
-COLORS: Static color modes
C1: White color
+
-BRIGHTNESS: After pushing
-
Winterizing
To prevent damage to your STARBRIGHT, you must remove most of the assembly parts for winter.
Only the main body (1), the wall plate (2) and the two wall gaskets (6) can remain.
See image of step 2 for reference.
Spring pool opening
Apply silicone grease to all your STARBRIGHT o-rings before reassembling.
M10066C
DETAIL
3
6
10
Raise the water level to the
appropriate level for your pool.
M
you can adjust the speed to wich the colors will change (8 levels).
C
you can adjust the brightness level (8 levels).
INSTALLATION
GUIDE
4
4
Screw the compression nut (3)
DO NOT TIGHTEN. Position the
7
STARBRIGHT
Install your AC adapter preferably sheltered from the elements.
Connect the light to your AC adapter. Read the following
instructions before connecting to power outlet.
STARBRIGHT
9413-2800
3
Screw the compression nut (3)
until you feel a slight resistance.
Complete by adding a1/4 turn.
DO NOT OVER TIGHTEN. The water
tightness is not determined by the
compression nut.
+
M
C
-
AC
ADAPTATER
POWER OUTLET
(NOT INCLUDED)
AC Adaptor 60Hz/12V
94-1320-12R
COLOR RING
MODE RESET
+
M
C
-
Remote control
94-1320-70
3
M
C
2
Publicité
