Renovator Paint Runner Pro Mode D'emploi page 9

Reinigen der Kantenrolle
1. Verschlussgriff abheben und zum Öffnen gegen den Uhr zeigersinn drehen.
2. Größere Mengen Farbe umweltgerecht entsorgen.
3. Verschluss und Schutzplatte abnehmen und abspülen, bis sie sauber sind (Abb. 10). Für
sofortigen Einsatz auf Papier oder Tuch trocknen bzw. für späteren Einsatz an der Luft
trocknen lassen.
For best results, please read this owner's manual thoroughly before using your
Paint Runner and accessories.
1. Only use acrylic or latex paints (no enamel or oil-based paints).
2. Always stir paint thoroughly before use.
3. If paint is too thick, mix in a little water as per manufacturer's instructions to achieve
desired consistency.
4. For a quality finish, always apply two coats.
5. Only apply the second coat when the first coat is completely dry.
6. As with all DIY/Decorating activities, always make sure that you take the appropriate
safety precautions.
7. If Edger Head is loose, it has not been pushed on to the handle firmly enough. Do not
be afraid to use a little force to secure the Edger Head.
Preparing your Paint Runner for use
1. Before first use rinse the roller under a tap then dry.
2. Remove the Open Cap from the Paint Runner.
3. Pour up to 1 litre of paint into the Paint Runner Pro using the Easy Pour Jug (Fig.). To
accomplish best results, we recommend filling in a maximum of 900 ml
4. Replace the Open Cap and make sure it is thoroughly secure (It should click into place).
5. You now need to 'charge' the Paint Runner. Do this by rolling it on old newspaper for
2-3 minutes applying a bit of pressure, until paint is visible all over the roller (Fig. 2).
Using the Paint Runner
1. Make sure you are happy with the weight of the Paint Runner. If not, carefully remove
ALWAYS READ INSTRUCTIONS BEFORE USE
YOUR PAINT RUNNER IS NOW READY TO USE!
EN
Hergestellt in Indonesien
9