Publicité
FEATURES:
• The cup has double stainless steel wall design for heat preservation.
• The lid is made of food-grade PC material which resists high temperatures.
• The seal ring is made of food-grade silicone.
• The liquid temperature is controlled electronically to become the temperature you select
• Normal heating time is 10-25 minutes depending on the temperature of the liquid poured into the mug
and the temperature selected.
WARNING, LIQUIDS INSIDE MUG WILL BECOME VERY HOT! USE CAUTION!
TEMPERATURE SELECTION:
• LOW: Suitable temperature for drinking warm liquids or soup.
• MED/LOW: Most comfortable temperature for drinking coffee or tea.
• MED: Suitable temperature for drinking coffee or tea.
• HIGH: The best temperature for steeping tea, making instant coffee or hot chocolate.
• MAX: Use only for making high temperature liquids/soups.
MAX temperature selection not recommended for drinking, serious burns may occur.
The panel has fi ve temperature scales, Low, Med Low, Med, High and Max. Next to each scale is an
indicator light which has four color modes to let you know the temperature of the liquid.
• Off: Indicates you did not set the temperature.
• Blinking Red: Indicates you have set the temperature.
• Red: Indicates the mug is heating to the selected temperature.
• Green: Indicates the set temperature has been reached. (The highest green light indicates the
current temperature.)
Operating Instructions:
NOTE: Make sure the lid and mug are cleaned thoroughly before using.
1. Fill the mug with your desired beverage, hot or cold. Liquid should be 1/2" below the bottom of
the lid. Too much liquid can cause a spill.
2. After fi lling with liquid, screw lid on tight. Never use the mug without the lid secured. Hot
beverages may spill causing a burn.
3. Plug the power cord into the mug. Insert the plug with the notch to the outside.
Do not force the plug into the mug, damage may occur.
4. Plug the DC end into a 12-Volt power port with a minimum 10 Amp fuse.
5. Press the "SET" button until a blinking Red LED is at the desired temperature.
6. Once the selection is made, the Red LED will stop blinking and the mug will start heating.
7. Once the selected temperature is reached, the LED will turn Green.
NOTE: If you fi ll the mug with a liquid hotter than the selection made, the mug will indicate the current
temperature. In order to lower the temperature of your liquid, turn the mug off and allow it to cool down.
Once the liquid has cooled, you may then turn on the mug to maintain your desired temperature.
Publicité
