Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UK
Fitting the pan supports and water
trays
1. Place support bar on the ladder at the desired
height, mounting the rear end of the support
bar to the ladder first.
Ladders
2
Support bar
2. Repeat for the remaining support bars.
3. Slide the GN pans/shelves into place.
4. Fix the water trays as instructed below.
Square water tray
Rectangular water tray
Directly push into the
Hang onto the pre-
support brackets on
mounted bolts on the
the underside of the
interior back wall, ensuring
cabinet.
it is fixed in place.
Brackets
4
CP829_ML_A5_v2_20181217.indb 4
1
Bolt
Water tray
Operation
Control panel
The control panel is
located above the
door on the front of
the appliance.
Turn On
1. Put the food in and close the door.
2. Connect the appliance to a mains power supply.
3. Press and hold
for 3 seconds.
Adjusting the Temperature
1. Press
for 1 second. The set temperature will
flash.
2. Press the up button
or down button
change the set temperature.
3. Wait 6 seconds for the set temperature to be
stored.
Parameter Setting
The operating parameters of this appliance have
been preset for optimum performance and to
maximise the life of the appliance.
The default value of set temperature is 75°C.
Para-
Function
meter
PAS
Password
E1
Lower setpoint
temperature
E2
Upper setpoint
temperature
E3
Temperature
hysteresis
E4
Time delay of
starting machine
E5
Temperature probe
adjustment
Cabinet
Temperature
Display
Fan On
Down button
On / Off button:
Press and hold for
3 seconds to switch
system on / off
Up Button
to
Range
Default
0 ~ 100
15
25°C ~ SET
70°C
SET ~ 85°C
82°C
1°C ~ 10°C
4°C
1 ~ 8 min.
3 min.
-5°C ~ +5°C
0°C
2018/12/17 15:27
Publicité
Table des Matières
