Led Light - M Confort V360 Manuel De L'utilisateur

3.Sleeping wind ：
The speed led display do not change as the wind speed at natural and sleeping mode,
6.TIMER
After turned on, there is no time setting by default and no TIMER led display. Press
the TIMER button, you can set the running time for this fan, Time setting as: 1H,
2H, 4H, 8H,no time setting,1H,circulating as this, and the led light changed
according. After the time setting, the system enters into the countdown and works
until the unit turns off.
7. FUNCTION CONSERVATION
When in standby mode, wind speed and oscillation will all be conserved. (Timing &
sleeping mode will not be conserved)

8. LED LIGHT

The LED light has dimming function if no operations on buttons in 1 minutes (33%
darkening than original brightness). If press the button again, the light will
brighten.
Usage for remote control
1. Open the battery box on the back of remote control, and install One button
battery (CR2032 3V).
2. Allign to the remote control receiver. The RC will not work when blocked. Well
keep the remote controler, do not throw it to the floor. Put it in the handle.
3. Replace the battery after power off. Please note the positive & negative of the
battery.
High:30 minutes' high natural wind—30 minutes' medium natural
wind-low natural wind(keeping)
Medium:30 minutes' medium natural wind—low natural wind(keeping)
17