Publicité
Les langues disponibles
Les langues disponibles
English
1.
To fix the tool holder to the machine,
introduce the shank and use the pin for
the positioning.
Then tighten the 2 screws of fixations.
(Important, make sure that the screws
have the same strength of tightening).
2.
Adjust the offset of the position.
3.
Adjust the desired angle by loosening
the 2 screws with mark No. 1.
Zone industrielle C
Rte du Grammont 101
CH-1844 Villeneuve
Mode d'emploi
Operating instructions
Betriebsanleitung
Istruzioni per l'uso
GSA-407
4. During the mounting or the dismounting
of your cutting tools, block the broach
on flats planned for that purpose, using
an adapted wrench.
5. The tool shank diameter should never
have a difference of more than 0.4 mm
compared to the clamping diameter of
collet
Example: clamping diameter 9.5 mm =>
Shank diameter 9.1 mm minimum.
NOTE :
positions. Use the supplied protection plug.
PCM WILLEN SA
SWISS MADE
Copyright © PCM Willen SA.
Garant:
BT
Validation : 27.03.2013
never use the tool holder with empty
Tél ++41 21 967 33 66
Fax ++41 21 960 38 95
http://www.pcm.ch
email:
office@pcm.ch
Document :
GSA-407 Mode
d'emploi 1-
Page : 2 de 4
Publicité
