SNOWJOE Sun Joe RJ205M Mode D'emploi page 3

Assembling the Roof Rake +
Adjusting the Handle
1. Remove the shipping cap from the top of the pole. Retain
for storage (Fig. 1).
Cap
Fig. 1
2. Unscrew the handle knob and extend the pole to expose
the small holes (Fig. 2).
Fig. 2
3. Depress the small buttons at the end of the handle so
that you can insert the handle into the roof rake head
(Fig. 3).
Fig. 3
Hole
Buttons
4. Using the hex key wrench, screw the metal braces to the
roof rake head with the two short hex screws and secure
the screws with the locking nuts (Fig. 4).
Short hex Metal
screw braces
Fig. 4
5. Affix the metal braces to the pole by threading the long
hex screw through the metal braces and the pole. Secure
the screw with the locking nut using the open end wrench
(Fig. 5).
Long hex
screw
Fig. 5
3
Short hex screw
Locking
nut
Hex key
wrench
locking nut
Open
end wrench