Blaupunkt BLP3720-001 Mode D'emploi page 14

5. Volume +
Charging the product
Note: The internal battery must be fully charged before first use of the speaker.
To charge the battery, insert the micro-USB connector of the USB cable into the charging input
hole and then plug the USB connector into either the USB port on a computer or into a
compatible USB wall charger (not included) to charge through a standard wall outlet.
The red LED indicator lights up during charging and will automatically go off when charging is
complete.
Note: When battery power is low, the speaker may emit a beeping tone, even while music is
playing. Fully charge the battery as advised above to resume normal operation.
Once the speaker has been charged switch the device on by holding the on/off button.
Pairing the product
If you want to pair your mobile device or computer with the speaker please make sure the
Bluetooth mode on your device is switched on.
Hold the power button for 3 seconds to pair the device.
After doing so the speaker will be visible in the Bluetooth devices overview of your device. Select
"BLP3720" to pair your mobile device with the speaker.
Declaration of conformity UE
Dag Technologie®, herby declares that this equipment, conforms to the essential requirements
and other relevant provisions of Directive 2014/53/UE. The declaration of Conformity can be
viewed at the following address:
http://www.mms-support.net/OTA/ECD_DAG_BLP3720-001.pdf
The European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE),
requires that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain, and reduce the impact on human health
and the environment. The crossed out "wheeled bin" symbol on the product reminds you of your
obligation, that when you dispose of the appliance, it must be separately collected.