Varan Motors NEPW-04 Manuel D'utilisation page 11

OPERATION
1. Wear suitable protective clothing, gloves and goggles.
2. Clean off any accidental splashes of degreaser on skin immediately, following the degreaser manufacturer's
instructions carefully. Seek medical attention if necessary.
3. Keep work area tidy and mop up any accidental spills of degreaser.
4. Do not allow the level of liquid in the parts washer to fall below the pump inlet, as damage to the pump can result.
When not in use:
1. Switch off pump, close the lid and disconnect from the electrical supply.
2. Disconnect from the electrical supply before carrying out any maintenance or cleaning on the parts washer.
NOICE: The pump of your parts washer may be damaged if you use solvents such as methylethylketone (MEK),
perchloroethylene or trichloroethylene. Use only water-base solvents with this parts washer.
ASSEMBLY
1. Remove parts washer from carton and inspect for any visual damage.
2. Remove parts inside the machine.
3. Place clean cardboard on the floor and lay machine on its lid. (Make sure you hold cover closed when laying
machine on its lid.) Mount four legs on brackets with M6X12 Philips head screws and M6 nuts. NOTE: DO NOT
TIGHTEN.
4. Place lower shelf between legs with flat surface up and attach to legs with M6X23 Philips head screws and M6
nuts.
5. With legs pressed tight against lower shelf, tighten all screws to lower shelf.
6. Tighten all the screws installed in Step 4.
7. Stand machine up, being careful to hold lid closed.
8. Put work shelf and basket into the machine.
9. Mount pump assembly into slot on the side of the machine, then place filter screen in position.
10. Plug machine into standard 230 Volt 50hz grounded outlet and fill with proper amount of fluid-
11. Turn switch on. Fluid should be flowing from the flexible spigot.
When installing your parts washer:
1. Assemble it according to the instructions given below.
2. Sit it on firm, flat, level surface in a well-ventilated area and away from any open flames.
3. Fill only with a non-flammable water-based degreaser or cleaning agent to just below the level of the parts shelf
(approximately 20 gallons).
4. Follow the degreaser manufacturer's instructions carefully.
5. Do not fill with flammable solvents such as kerosene, gasoline, etc.
Varan motors
BCIE SARL, gruuss-strooss 28, 9991 Weiswampach, Luxembourg
T: 00352/26908036 – F: 00352/26908040
NEPW-04