Dräger RH 600 Notice D'utilisation page 42

Radiateur thermique pour nourrissons
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Operation
Using skin temperature control
The system initially proposes the default temperature
setting 36.3 °C.
1 The value 36.3 °C flashes in the display.
2 Briefly press and release p or P to confirm the
value.
1 The displayed value remains constant.
The temperature setting can be adjusted in 0.1 °C steps:
2 Hold down key p or P until the desired temperature
setting appears in the display.
O
3 The yellow LED
lights up or flashes according to
the adjustment (heater function display).
To check heater function during operation:
4 Press the 6 key.
5 The simulated temperature value must be 36 °C
(±0.1 °C) (function check).
If the sensor probe is disconnected or the sensor is
defective:
6 Three flashing dashes in the middle of the display
7 the red alarm LED marked Sensor flashes.
A continuous audible alarm tone is emitted.
Immediately connect the sensor plug or change the
skin temperature sensor.
If the error cannot be remedied immediately:
Remove the skin temperature sensor from the patient.
Switch to manual mode (»Man«).
See "Troubleshooting", page 50.
42
2
2
1
5
4
6
7
3

Publicité

Table des Matières
loading

Table des Matières