Over Temperature Protection - RIDGID R8694221 Manuel D'utilisation

OPERATION
Hanging the panel light using the hooks:
 Hang the panel light from a sturdy location like a fence
using the built-in hooks.
Mounting the panel light to a rod using the rod pocket:
 The panel light can be mounted on rebar or a rod or tube
using the pocket on the base of the panel light.
NOTE: The mounting post must have a diameter less
than 0.66 inches.
Mounting the panel light to a tripod using the tripod
mounting hole:
 Place the panel light on the tripod mounting screw. Make
sure the mounting hole on the base of the panel light seats
completely on the mounting screw.
 Turn the panel light clockwise to secure.

OVER TEMPERATURE PROTECTION

If overheating occurs, the panel light will attempt to cool itself
by dimming. If dimming does not cool the light sufficiently,
it will shut off. As soon as the unit reaches normal operat-
ing temperature, it can be turned on again. If the panel light
shuts off, allow approximately 10 minutes of cool-down time
before attempting to resume operation.
8 – English