Westpoint WMC Série Manuel D'utilisation page 5

Warning! For transport reasons, the suspended unit located in the machine is locked
in position by four distance pieces and screws. Before operating the machine, remove
the blocking screws and insert four plastic caps to each hole accordingly.
(Fig.3) Save the screws and distance pieces for future use.
Once the screws and packing spacers have been removed, it is necessary to insert the
plugs provided, which can be found inside the bag containing the documents.
C
Installation
The appliance must be positioned so that the plug is accessible.
For proper operation, the machine should be installed on a flat, level surface.
Levelling can be carried by adjusting the feet (Fig.4) on the machine.
Once the machine is level, block the feet by tightening the lock nuts with a spanner.
C
Electrical
Connection corresponds to the mains supply voltage.
The counter, pressure relief valve, supply lines and power connection have all been
designed for the maximum load requested.
Insert the plug in the socket, ensuring that it is fitted with an earth (Fig.5)
If the electrical socket in which the plug of the machine is inserted is unsuitable, have
the socket replaced by qualified personnel.
It is good practice to avoid the use of adapters, extension leads and multiple sockets*.
T
urn on the tap and allow a good quantity of water to flow until it is clear and free from
Water
impurities. This procedure is especially applicable in the case of new water systems or
connection
those that have remained unused for some time.
Connect the water supply hose to the tap; inserting the filter provided, and hand
tighten (Fig.6). Check that the other end of the hose is tight on the inlet (Fig.7).
Position the discharge hose at a minimum height of 60cm, though not more than 90cm,
from the ground (Fig.8).
N.B. To prevent siphoning, do not hermetically seal the machine's discharge
hose.
Remember that the hoses must not be squashed when manoeuvring the machine
against the wall.
The appliance is to be connected to the water mains using new hose-sets and that old
hose-sets should not be reused.
Fig 3
4
arefully transport the machine to the connection points.
heck that the voltage written on the technical data table inside the manual
* See warnings (page 2)
Fig 4
Fig 7
Fig 5
Fig 8
Fig 6