Table des Matières
Publicité
pottery barn kids – Pbteen – Pottery Barn – west elm – Williams Sonoma Home – Rejuvenation – Mark and Graham
2019.04.18
WARNING: This product is only a deterrent. It is not a substitute for proper adult supervision. Manufacturer assumes no liability for
improper installation or excessive loads placed on screws, brackets or straps.
Young children may be injured by tipping furniture and the use of a tipping restraint is highly recommended.
When properly installed, this restraint will provide protection against tipping of furniture. This tipping restraint MUST be secured to a
wall-stud or wall structure of similar strength.
----------------------------------------------------------------------------------------------------------------------------------------------------------------
Hardware Included:
(2) Brackets 48 x 21 x 10mm
(2) Stud Mounting Screws #8 x 38mm
Note: For safe mounting it is essential to use the proper hardware for your wall type.
If the mounting bracket cannot be secured to a wall stud because of inappropriate spacing and/or because you have a different wall
type
(e.g., plaster, concrete,
To install:
1)
LOCATING THE STUDS: Use a stud finder to locate the vertical wooden studs within your wall located behind the final
position of the furniture item. Mark the stud locations with a light pencil-mark.
2)
MOUNTING THE FURNITURE-SIDE BRACKET: Move the furniture item close to the wall to its final position. Use pieces of tape
or a pencil to transcribe the stud locations of the wall onto the furniture item. Move the furniture item again so you can access its back
and use the marks to locate a suitable mounting point for the furniture-side bracket. Make sure that the bracket is secured to a firm
portion of the furniture frame and as high as possible. Remember: The furniture-side bracket must be positioned near a wall stud.
Using a pencil, and the bracket as a guide, mark "screw marks" on the furniture item through the bracket holes
Use a 3/32" drill bit to drill pilot holes into the furniture item at the "screw marks". Use the TWO Short screws to secure the
furniture-side bracket. This bracket can be positioned either vertically or horizontal as necessary (See Figure 1).
3)
MOUNTING THE WALL-SIDE BRACKET: Position the wall-side bracket along the selected stud mark so that it will be adjacent
the furniture-side bracket when the furniture item is moved to its final position. The wall-side bracket should be about ONE inch lower
than the furniture-side bracket (See Figure 3). Use the TWO Long screws to secure the wall-side bracket to the wall. Remember to
position the wall- side bracket vertically so that both screws will engage the selected wall stud (See Figure 2).
4)
ATTACHING THE STRAP: When both bracket are securely attached, move the furniture to its final desired position and thread
the strap through the openings of each bracket and also through the ratcheting "buckle". Tighten the strap until several "clicks" are
heard. The furniture item is now securely tethered to the wall.
Note: If you must move the furniture item, you can release the strap by depressing the lever arm located at its buckle and
simultaneously with drawing the strap from the buckle. Make sure to reconnect the strap once the furniture item is returned to its
previous position.
Figure 1
Williams-Sonoma Inc.
FURNITURE TIPPING RESTRAINT
brick etc.)
please consult your local hardware store for fastener advice.
Figure 2
(1) Nylon Strap 300 x 12 x 8mm
(2) Product Side Mounting Screw #8 x 20mm
The included hardware is for stud mounting only.
Figure 3
Assembly instructions
Instructions d'assemblage
Instrucciones de Ensamblaje
6/8
Publicité
Table des Matières
