Talento 371 Mini Plus Mode D'emploi page 13

Safety precautions
· The connection and installation of electrical devices may only be carried out by a qualified
electrician.
· Interventions in and changes to the device result in the voiding of the warranty claim.
· Observe your national regulations and the respective safety provisions.
· Fixed and flexible conductors of up to 2,5 mm
· Flexible cables with a cross-section ≤ 1 mm
General information
· Deactivation commands take priority over activation commands.
· If the power supply is correct, the dots shown between the hours and minutes (HH:MM) are
displayed permanently. The dots flash if the power supply is interrupted.
· If there is no power supply, the position indicator display goes out after 1 minute (sleep-function).
· The whole display flashes the battery needs to be changed for up to 2 weeks to warn that.
Installation on DIN rail
Battery change
– –
GB
may be attached to the external terminal clips.
2
should not be attached.
2
Type: CR 2032
Terminal diagram
3 2
M ~
1 L
N
L
Attention!
· The battery change may only be carried out
by a qualified electrician!
· Isolate the device before replacing the
battery!
· Check battery polarity when replacing.
13
C1
N 1 2 3