Operation - Ryobi P2402 Manuel D'utilisation

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
WARNING:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
NOTICE:
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced. Please contact customer service or a qualified
service center for assistance.
APPLICATIONS
 Spreading granular and pellet grass seed, fertilizer, weed
control, and deicer products
INSTALLING/REMOVING BATTERY PACK
See Figure 2.
WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.

OPERATION

To install:
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
To remove:
 Depress the latches and remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger.
USING THE SEED SPREADER
See Figures 3 - 4.
NOTE: Before beginning, determine the size of your application
area and make sure you understand the regulations and
requirements of the product you are applying. Be careful
not to overapply the product.
 Place the seed spreader on a flat surface and fill the bin
with the product you wish to apply. Do not overfill.
 Using the dial, choose a broadcast setting based on your
application needs. Refer to the packaging of the product
you are applying to determine the appropriate setting. If
no setting is given by the product manufacturer, refer to
General Application Settings that follow.
 If needed, adjust the edge shield to restrict the broadcast
area on one side to avoid areas you do not wish to cover
like driveways, sidewalks, etc.
 Depress the switch trigger to begin spreader broadcast
and walk the outside border of the area you wish to cover.
Release the switch trigger when finished.
NOTE: Make sure to walk at a steady pace to apply an
even amount of the product to the desired area. Walking
too slowly or too quickly will cause the amount of product
being applied to be too heavy or too thin.
 If needed, adjust the edge shield to restore the broadcast
area to its full width.
 Depress the switch trigger to begin spreader broadcast
and walk the inside area you wish to cover in uniform
parallel passes until the desired area is covered. Release
the switch trigger when finished.
 Remove the battery pack from the spreader and return any
unused material back into the original product container
or bag.
7 — English