Battery Warning; Maintenance And Care - Noblex NR 1000 Mode D'emploi

MEASURING SEQUENCE
After the switch-on button " " (C) has been pressed, the circle of the dis-
played target mark " " (1) must be aligned with the target object.
If the switch-on button is pressed again, the distance of the object is mea-
sured and shown in the display. In the field of view, one can recognize the
activation of the laser by the symbol " " (9) appearing around the circle of
the target.
It should be noted that, for a reliable measurement, the " " button must be
pressed the second time so long until the distance value is displayed (about
2 seconds). If no value is displayed after 3 seconds, the reflection on the
object is too bad and no distance can be measured. If this is the case, the
message "END" appears in the display.
Scan mode
Furthermore, the laser rangefinder has a scan mode.
If the device the unit is moved while keeping the switch-on button " "
pressed, the range and angle measured values are constantly updated.

BATTERY WARNING

If " "appears in the lower left corner of the field of view (8),it means that
the battery power is inadequate and the rangefinder will either shut off
automatically or cannot be started properly. In this case, the battery in the
battery compartment must be replaced.

MAINTENANCE AND CARE

The laser rangefinder requires no special care, it is virtually maintenance
free. Optic external surfaces must be cleaned with a fine brush or a soft
cloth if necessary. Coarse dirt particle should be rinsed off or blown off
before wiping. An excessive rubbing when brushing the optical parts can
destroy the anti-reflection coating. No chemical solvents should be used and
the device should be stored dry!
Always press only 1 button. If you do not use the device for a long time, you
should remove the battery.
Please do not dismantle and repair the device yourself, otherwise the guar-
anteed services will no longer be valid.
15