Delta LA200 Manuel D'utilisation page 9

ATTACHING THE LIVE CENTER TO THE TAILSTOCK
The supplied tailstock live center (A) Fig. 10 is equipped with a No. 2 Morse Taper shank (B). This center comes inserted
in the tailstock spindle. To remove the live center (A) Fig. 11 from the tailstock spindle, loosen the lock knob (C) and rotate
the handwheel (D) to push the live center (A) out of the spindle (B). Use the knockout bar through the hollow tailstock (F) to
remove the center point (E).
A
To use the faceplate for inboard turning, mount the faceplate to the headstock spindle (shown without a workpiece for
clarity).
1. Install the spacer (A) Fig. 12 on the headstock spindle (B).
2. Thread the faceplate (C) Fig. 13 on spindle. Insert the knockout bar (D) into the hole in the spindle to keep it from turning.
Tighten the faceplate (C) with the supplied wrench (B) on the flats.
FASTENING THE LATHE TO A SUPPORTING SURFACE
You must fasten the wood lathe to a supporting surface.
Four mounting holes (three of which are shown at (A) Fig.
14 are provided in the base of the lathe.
B
Fig. 10
A
B
C
Fig. 12
B
E
A
D
B
C
A
9
C
F
D
Fig. 11
Fig. 13
A
Fig. 14