Important Safety Instructions For Charger & Battery - Genesis GLRT08B-65 Manuel D'utilisation

Wire and bristle brushes must never be operated at speeds greater than
•
15,000 RPM
particles and tiny wire fragments may be discharged at high velocity during cleaning use with these bristles
and become imbedded in your skin. Bristles or wires will be thrown from the brush at high speeds.
Wear protective gloves and face shield when using wire or bristle brushes
•
Lightly apply wire or bristle brushes to the work; only the tips of the wires and bristles do the work. Heavy
pressure on bristles overstresses the wire or bristles and will cause them to be discharged.
When using grinding wheels or similar attachment
•
carefully to avoid chipping and cracking. If the tool is dropped during use, install a new grinding wheel. Do not
use damaged wheels or wheels that may possibly be damaged. Damaged wheels may burst during operation
causing fragments to fly away high speed possibly striking you or bystanders causing personal injury.
Handle sharp bits with care and never use dull or damaged bit
•
may snap during use. Dull bits require applying more force to move the tool, possibly causing the bit to break.
Always use clamps or similar devices to secure the work-piece at all times
•
Never hold the work-piece in one hand and the tool in the other to perform work. Allow sufficient space
between your hand and the spinning bit to prevent injury due to "kickback". Round work pieces such as
dowel rod, pipe, and tubing tend to roll while being cut often causing the bit to bite into or jump toward you
possibly causing personal injury.
Always inspect the work-piece before cutting
•
pinch the bit, causing the user to loose their grasp on the tool.
Never start the tool when the bit is engaged in the work-piece
•
may grab the material causing loss of control of the cutter.
Always use the proper direction of feed when carving, routing or cutting
•
feeding the tool in the wrong direction may cause the bit to climb out of the work-piece and/or unexpectedly
pull the tool in the direction of the feed causing possible loss of tool control.
If the bit becomes jammed or bogs down in the work-piece, turn the tool
•
"OFF" with the switch.
in the "ON" position, the tool could restart unexpectedly causing serious personal injury.
Do not leave the tool running unattended!
•
safe to put down.
Do not grind or sand near flammable materials.
•
materials to ignite.
Do not touch the bit or collet after us
•
bare flesh.
Do not alter or misuse the tool.
•
serious personal injury.
This product is NOT intended for use as a dental drill in human or veterinary
•
medical applications.
IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER &
BATTERY
Save these instructions.
•
battery charger.
Before using the battery charger,
•
Charger, (2) Battery, and (3) Product using battery.
Use only the charger
•
manual. Do not substitute any other charger.
Do not recharge the battery in damp or wet environments
•
battery pack to water or rain.
Do not operate the charger with damaged cord or plug
•
6
and the discharge of the spinning wire brush must be directed away from the user. Small
Wait for all moving parts to stop, free the jammed material. If the switch is left
Serious personal injury may result.
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for your
which accompanied your product or direct replacements as listed in this
8V Lithium-ion Rotary Tool
Operator's Manual
. Cutting irregularly shaped work pieces may
Only when the tool comes to a complete stop is it
Sparks from the wheel could these
e, they are too hot to be touched and will cause burns to
Any alteration or modification is a misuse and may result in
read all instructions and cautionary markings on (1) Battery
GLRT08B-65
s, handle the tool and wheels
s. Damaged bits
. The bit cutting edge
. Do not expose the
. Replace immediately.
.
.
.