Electrolux ARTHUR MARTIN AFF9671MK Notice D'utilisation page 10

10
CONTROLS
The hood is fitted with a control panel with
aspiration speed selection control and a
light switch to control cooking area lights.
Use the high suction speed in cases
of concentrated kitchen vapours. It is
recommended that the cooker hood
suction is switched on for 5 minutes prior
to cooking and to leave in operation
during cooking and for another 15 minutes
approximately after terminating cooking.
T1 Button Speed (power) of suction 1
T2 Button Speed (power) of suction 2
T3 Button Speed (power) of suction 3
T4 Button ON/OFF Speed (power) of
suction 4
Note: The Speed (power) of suction 4
remains in function for 5 minutes, then
the it returns to the previous setting.
T5 Button for filter saturation control
T6 Button OFF speed
Button for control panel activation-
deactivation
T7 Button ON/OFF lights
Button for activation/deactivation of
charcoal filter saturation control
Delayed switch-off function for the
suction speed (power):
Select the desired speed and press the
same button again for more than 2 sec.;
the button flashes to indicate that the
function has been activated. Press again
to deactivate the function.
The selected speed will turn off after:
Speed (power) of suction 1: 20 minutes
Speed (power) of suction 2: 15 minutes
Speed (power) of suction 3: 10 minutes
Speed (power) of suction 4: 5 minutes
T7 T6
The control switches are located on the
unit's front panel.
Note: a remote control can be purchased
apart, contact the local authorized dealer.
Note: The hood is equipped with a
protection system against disturbances of
the mains power network; in case of peaks
exceeding 2kVolts, the hood will reactivate
autonomously after approximately two
minutes from the last disturbance.
T1 T2 T3
Function Activation – Deactivation
control panel
Press the T6
seconds
Function Activation – Deactivation
control of charcoal filter saturation
With the hood off press the
more than 5 seconds.
Button T5 flashes:
Twice to indicate that the saturation
control for the charcoal filter has been
activated
Once to indicate that the saturation control
for the charcoal filter has been deactivated
Function of filter saturation control and
reset
At regular intervals, depending on how
long the hood is used, the button
to indicate that it is necessary to carry out
the maintenance of the filters according to
instructions in the related paragraphs.
Button T5 lights up with steady light: it is
necessary to perform maintenance on the
grease filter
Button T5 lights up flashing: it is
necessary to perform maintenance on the
charcoal filter.
T4 T5
button for more than 5
T7 button for
T5 lights