Geemarc LOOPHEAR LH160 Mode D'emploi page 4

INSTALLATION & OPERATION
Choose a suitable location, free from
magnetic or electrical interference for
installation and use of LH160
(1) Install the LH160 onto a panel or
wall under the counter, ensuring that
the cables are securely anchored.
(2) Connect the loop antenna (optional
accessory) or other compatible loop
coil to the loop output terminals. For
optimal performance the loop antenna
or coil should be located about 80cm in
ftront of the customer.
Press the tab above the connector
terminal and release after inserting the
wire of the loop antenna or coil. Polarity
is not important.
(3) Connect a compatible Geemarc
Microphone to the Mic1 jack.
(4) If required connect a second
compatible Microphone or Aux input to
the Mic2/Aux jack. Use the switch to
select the type of input.
(5) Using a small common blade flat
screwdriver, turn the Mic1, Mic2/Aux,
Tone and Field Strength controls fully
anti-clockwise (to their minimum levels).
(6) Select the power source (car battery
or mains AC adaptor) and connect the
car adaptor cable or AC power adaptor
to the power input socket.
3