Luca Trazzi X4 Manuel D'instructions page 15

x 4 T I M E
Programming the X4
The X4 allows the following functions to be
programmed:
Clock time
Sleep/active modes
Temperature at which coffee is prepared
Duration of coffee preparation
Programming the clock time
Depress the temperature button (2) for
approximately 3 seconds. The time display
will flash.
Use buttons (3) and (4), to set the hours.
Press button (2) again to set the minutes.
You have now set the clock time.
Press button (2), (or after a few seconds) this
time wil be displayed.
If the time is shown on the display, the X4 is in
sleep mode. This means that the machine is
in an energy-saving mode while retaining full
programmed functionality. If you want to use
the machine while it is in SLEEP mode, just
press button (2), the temperature will be
displayed and the machine will be in ACTIVE
mode. When the cup stops blinking, you will
be able to prepare an espresso.
NB: Unplugging the machine, or using the
on/off button (1) to turn it off will result in the
loss of any machine setting you have
programmed after about 8 hours. When the
machine is turned on again , the machine will
revert to the factory "default" settings.
26
x 4
3 sec.
+ -
+ -
P R O G R A M M I N G
Programming the switch on /
switch off function (P1,P2,P3)
This function allows you to program three
active periods for the machine throughout the
day (P1, P2 and P3). On the display, you will
see "L'ORA" (TIME).
To program P1, proceed as follows:
Press button (2) for approximately 3 seconds.
Next, press the same button two more times.
P1 will now be displayed.
Now press button (3) or (4): the clock time for
the ACTIVE function will appear and flash.
Press buttons (3) and (4) to set the hours.
Press button (2) once again to set the
minutes. Now, press button (2) a further time,
to change the clock time for the sleep
function.
Set the clock time as described above. Now,
wait a few seconds or press button (3). The
display will revert to showing the current clock
time and also show the word 'PROGRAM'.
(This means that at least one of the three
programs is active).
3 sec.
+ -
+ -
27