Safety Regulations; Layout And Items Supplied; Proper Use; Technical Data - EINHELL Professional TP-RH 40 E Mode D'emploi D'origine

Important!
When using the equipment, a few safety pre-
cautions must be observed to avoid injuries and
damage. Please read the complete operating
instructions and safety regulations with due care.
Keep this manual in a safe place, so that the in-
formation is available at all times. If you give the
equipment to any other person, hand over these
operating instructions and safety regulations as
well. We cannot accept any liability for damage
or accidents which arise due to a failure to follow
these instructions and the safety instructions.

1. Safety regulations

The corresponding safety information can be
found in the enclosed booklet.
Caution!
Read all safety regulations and instructions.
Any errors made in following the safety regula-
tions and instructions may result in an electric
shock, fi re and/or serious injury.
Keep all safety regulations and instructions
in a safe place for future use.

2. Layout and items supplied

2.1 Layout (Fig. 1)
1. Dust protection
2. Locking sleeve
3. Operating mode selector switch
4. On/Off switch
5. Anti-vibration handle
6. Additional anti-vibration handle
7. Depth stop
8. Power controller
9. Brush wear / overload indicator
10. Power indicator
11. Clamping screw
2.2 Items supplied
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
•
If possible, please keep the packaging until
the end of the guarantee period.
Anl_TP_RH_40_E_SPK7.indb 17 Anl_TP_RH_40_E_SPK7.indb 17
GB
Important!
The equipment and packaging material are
not toys. Do not let children play with plastic
bags, foils or small parts. There is a danger of
swallowing or suff ocating!
•
Depth Stop
•
Original operating instructions
•
Safety instructions

3. Proper use

The tool is designed for drilling with hammer ac-
tion in concrete, rock and brick, as well as for chi-
seling work, always using the respective correct
drill or chisel bit.
The equipment is to be used only for its prescri-
bed purpose. Any other use is deemed to be a
case of misuse. The user / operator and not the
manufacturer will be liable for any damage or inju-
ries of any kind caused as a result of this.

4. Technical data

Mains voltage: ............................... 230 V ~ 50 Hz
Power input: ............................................ 1010 W
Idling speed: .................................... 200-350 rpm
Blow rate: .................................... 1900-3300 rpm
Drilling capacity in concrete/stone (max.): 40 mm
Protection class: ...........................................II /
Weight: .......................................................6.0 kg
Impact energy: .............................................8.7 J
Max. impact energy (short-time): ...................11 J
The impact energy values were measured with
the new EPTA 05 method and therefore may be
approx. 30% lower than the values taken with pre-
vious methods.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level ........................ 95 dB(A)
pA
K uncertainty ............................................. 3 dB
pA
L sound power level ........................ 106 dB(A)
WA
K uncertainty ............................................. 3 dB
WA
- 17 -
20.06.13 10:12 20.06.13 10:12