Cleaning, Care & Maintenance - Polar GG762 Mode D'emploi

UK
To avoid contamination of drink, please respect the following instructions:
• Opening the door for long periods can cause a significant increase of the temperature in the
compartments of the appliance.
• If the refrigerating appliance is left empty for long periods, switch it off. Then defrost and clean it
thoroughly. Let it dry well and leave the door open to prevent mould developing within the appliance.
• Clean regularly surfaces that can come in contact with drink and accessible drainage systems.
• Only load the appliance when it has reached the correct operating temperature.
Cleaning, Care & Maintenance
• Always switch off and disconnect the power supply before cleaning.
• Remove all bottles from the appliance.
• Warm, soapy water is recommended for cleaning. Cleaning agents may leave harmful residues.
• A POLAR agent or qualified technician should carry out repairs if required.
• Periodically clean the bottom of the wine fridge compartment to remove any build-up of condensation.
Defrosting
The unit has an automatic defrost cycle to reduce the build-up of ice, but occasionally a manual defrost
may be necessary. To manually defrost the appliance remove contents and switch off unit. Allow ice to
melt and dry cabinet before switching back on.
Troubleshooting
Fault
The appliance is not
working
Appliance is noisy or
works intermittently
Wine fridge cabinet is
not cold enough
Light is not working
Door will not close
properly
Condensation on outer
surfaces (glass)
6
GG762-GG763-GG764_ML_A5_v1_202105019.indb 6 GG762-GG763-GG764_ML_A5_v1_202105019.indb 6
Probable Cause
The unit is not switched on
Plug or lead is damaged
Fuse in the plug has blown
Power supply
Appliance is not level
Temperature set incorrectly
External environment may require
colder temperature
The door is opened too often
Door seal is worn
Light key is not pressed
Bulb has blown
Appliance is not level
Shelves are out of position
Door seal is dirty
Condensation may occur when the humidity is high and water particles in the
air contact with cold surfaces. This is normal, just wipe away with a dry cloth
Solution
Check the unit is plugged in correctly and
switched on
Call POLAR agent or qualified Technician
Replace the fuse
Check power supply
Adjust the feet to level the appliance
Check temperature and reset if necessary
Check temperature and reset if necessary
Only open when necessary
Call POLAR agent or qualified technician
Press the light key
Call POLAR agent or qualified technician
Adjust the feet to level the appliance
Check all shelves are properly inserted
Wipe clean with a damp cloth
2021/5/19 14:41 2021/5/19 14:41