ECOVACS WINBOT 7 Mode D'emploi page 19

No. Malfunction
WINBOT 7 stops
at the bottom of
the window being
4 cleaned and emits
beeps. Status Light
Indicator flashes
RED.
Possible Causes
Interruption of electricity
while WINBOT 7 was
cleaning due to power
failure, plug displacement,
or loose connection to the
Power
Solutions
A. Connect WINBOT 7 to the Power
Adapter and plug into the wall
receptacle. Press START/PAUSE
Button on the robot or on the Remote
Control twice and WINBOT 7 will
resume cleaning.
B. In case of power failure, and the
above solution does not work, please
move the Power Switch to the OFF
position and remove the robot from the
window. If power has resumed, move
the Power Switch back to the ON
position, place the robot on the window
again and restart.
17
EN