Beverage/Wine Racks; Stocking The Beverage Center; Lighting The Beverage Center - Jenn-Air JUB248RBCX Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Beverage/Wine Racks

To Remove and Replace the Racks
1. Pull the rack forward until it stops. Push in on the tabs to
release the rack. Continue pulling the rack forward and lift it
up and out of the rack supports.
2. Replace the rack by inserting the rack into the supports and
sliding it toward the rear of the beverage center.
To Remove and Replace the Bottom Rack
1. Lift the rack (front and back) up and pull straight out to
remove.
2. Replace the rack by pushing it straight back and over the
stop. Continue pushing the rack straight back and evenly until
it is in place.
A
A
A. Tabs

Stocking the Beverage Center

NOTE: For optimum beverage and wine storage, place white
wines at the top of the beverage center in the wine rack. Place red
wines at the bottom.
To Stock the Beverage Center
1. Start stocking the beverage center with the bottom display
rack.
2. Starting on the left-hand side, place the first bottle of wine on
the bottom of the rack with the neck of the bottle facing the
back of the beverage center.
3. Place the next bottle on its side with the neck of the bottle
facing the front of the beverage center.
4. Alternate in this manner until the display rack is full.
5. Pull the next rack forward.
6. Starting on the left-hand side, place the first bottle on the rack
with the neck of the bottle facing forward.
7. Place the next bottle on the shelf with the neck of the bottle
facing the rear of the beverage center.
8. Continue alternating in this manner until the rack is full.
9. Slide the rack into place and continue stocking each
remaining rack as described above.
10. Place juices, sodas or other canned beverages on the glass
shelves.

Lighting the Beverage Center

The beverage center has an interior light that comes on anytime
the door is opened. You may also turn the light on at any time by
opening the door and pressing the exterior switch located beside
the temperature control knob on the base grille.
NOTE: Leaving the light on for an extended period of time will
slightly increase the temperature of the beverage center.
9

Publicité

Table des Matières
loading

Table des Matières