Publicité
Les langues disponibles
Les langues disponibles
Wall mounting
The HD Max Ampli can be wall mounted by following the procedure below:
a) Slide out the clip located
next to the hook switch and
turn it upside down before
sliding it back into place.
Note – the clip will locate
into a recess in the handset,
which will hold the handset when wall mounted.
b) Fit the wall bracket (supplied with the
phone) under the base of the phone, locating the
tabs on the bracket into the slots in the phone.
c) Select an area of the wall where you would like to hang your
phone and check that there are no pipes or electrical wires
buried in the wall in this area.
d) Drill 2 holes and fix 2 screws at 10cm intervals, leaving the heads
of the screws protruding.
e) Align the keyhole slots in the rear of the phone with the heads of
the screws and slide down slightly downwards so that the heads of
screws locate in the slots. If necessary, adjust the screws so that
the phone hangs flat and holds firmly on the wall.
10
Publicité
