Cutting, Shredding, And Grating; Application Table - CTC CLATRONICS SMS 3455 Mode D'emploi

4. Plug the power cord into a properly installed earthed
socket.
5. Hold the handle with one hand so that you can simultane-
ously press one of the pushbuttons ( or TURBO). You will
obtain a better result if you work in pulse mode.
6. Disconnect the power plug from the outlet after use.
7. Immediately clean the device after each use as described
under "Cleaning".

Cutting, shredding, and grating

CAUTION:
Do not use the cutting, grating, and rasping set to process
soft cheese (e.g. Gouda), hard cheese (e.g. Parmesan), and
cooking chocolate.
Select a tool and the speed for the application according to the following table. Make a note of the indicated quantities and the
maximum operating times.
Product /
Type of preparation
Chopping fruits, vegetables,
herbs
Chopping hazelnuts/ walnuts,
almonds
Pureeing vegetables (add
some water)
Slicing meats
Crushing ice
Cutting up cucumbers, carrots
Shredding carrots, radish
Grating potatoes
Liquids, shakes
Cream
Beaten egg whites
Dressing
34

Application table

Quantity Tool
Min. 250 ml
Chopping knife
Max. 750 ml
Min. 100 g
Chopping knife
Max. 400 g
Max. 750 ml Chopping knife
Max. 500 g Chopping knife
Max. 750 ml Chopping knife
Max. 1.25 Liter Cutting insert
Max. 1.25 Liter Shredding insert
Max. 1.25 Liter Grating insert
Min. 100 ml Blending stick and
Max. 400 ml measuring cup
Min. 100 ml Egg beater and
Max. 400 ml measuring cup
Min. 4 Egg whites Egg beater and
Max. 250 ml measuring cup
Min. 100 ml Egg beater and
Max. 400 ml measuring cup
1. Pre-cut the food so that it will fit through the feed shaft (13).
2. Place the lid onto the bowl. Tighten it until it audibly clicks
into place.
3. Plug the power cord into a properly installed earthed socket.
4. Hold the handle with one hand so that you can simultane-
ously press one of the pushbuttons ( or TURBO).
5. Fill the feed shaft with your ingredients. Use the pusher (11)
to press the food down into the feed shaft. Apply moderate
pressure on the pusher. Pay attention to the maximum
filling capacity of the work bowl (1,250 ml).
6. Disconnect the power plug from the outlet after use.
7. Immediately clean the device after each use as described
under "Cleaning".
Pushbutton
or TURBO
TURBO in pulse
operation
or TURBO
TURBO in pulse
operation
TURBO in pulse
operation
or TURBO
or TURBO
or TURBO
TURBO
TURBO
or TURBO
Maximum operating
time
2 minutes
1 minute
2 minutes
1 minute
1 minute
3 Minutes
3 minutes
3 minutes
3 minutes
1 minute
2 minutes
2 minutes
3 minutes
1 minute
3 minutes