SOLAC CP7395 Mode D'emploi page 13

• The first time you charge the personal grooming appliance (1), it will take
approximately 24 hours.
• The appliance can only be charged when the switch is in the '0' position
(Fig. 3)
• When charging or recharging the appliance, the room temperature should
not be below 15ºC or above 35ºC, as this may affect battery life.
• Seven hours' charging time when recharging the appliance will give about
75 minutes' operating time.
• If the appliance is not used for a month, recharge it fully before use.
• For optimum battery life, use the appliance until the battery is completely
run down and then recharge it fully.
HEADS
A) Blades
This appliance has two blades:
a) 25-mm ceramic blade for beards and goatees (5)
b) 14-mm blade (6) for details such as sideburns, eyebrows, etc.
Two accessories can be attached to these blades (Fig. 8):
- Guide comb (8) for reducing the density of the facial hair (beard, goatee,
moustache).
- Telescopic guide comb with 5 cutting levels (7). This comb allows you to
adapt the cutting length according to your needs.
• Level 2: 2 mm
• Level 4: 4 mm
• Level 6: 6 mm
• Level 8: 8 mm
• Level 10: 10 mm
B) Shaving head (10): for comfortable shaving of facial areas, fixing the edge
of the beard, goatee, etc. and for finishing touches at the back of the
neck.
C) Head for nostrils and ears (9): for cutting ear and nostril hair.
BEFORE STARTING TO CUT
1. Check that the appliance is clean and that there are no traces of hair be-
tween the blades, as this could prevent it from working properly.
2. Use the comb to comb the hair to be cut (16)
SWITCHING ON
• Set the ON/OFF switch (5) in the "I" position (Fig. 6)
"I" position: normal speed
"Turbo" position: the fastest. Press the "turbo" button (4) on the rear of the
Cortapelos CP7395 13
appliance (1) and keep it pressed while you want to use
this speed.
13
26/6/06, 12:12:39