Introduction/Scopeof Supply; Transport And Storage - Unitest 8986 Mode D'emploi

Introduction/ Scope of Supply Transport and Storage
The instruction manual contains information
and references necessary for safe operation and
maintenance of the instrument.
Prior to using the instrument (commissioning / as-
sembly) the user is kindly requested to thoroughly
read the instruction manual and comply with it in all
sections.
Failure to read the instruction manual or to comply
with the warnings and references contained herein
can result in serious bodily injury or instrument
damage.
1.0 Introduction/ Scope of Supply
You have purchased a high quality measurement in-
strument of Ch. BEHA GmbH which will allow you
to carry out measurement over a long time period.
The company Ch. BEHA GmbH is a member of the
world-wide operating BEHA Group with its head of-
fice in Glottertal which also houses our develop-
ment centre. The BEHA Group is a leading organi-
sation for Test and Measuring instruments.
The UNITEST® TELARIS EARTH is characterised by
the following features:
• Determination of earth resistance or specific
earth resistance
• 2, 3, and 4-wire measurements possible
• Measurement in compliance with the Wenner
method
• Measurement current exceeds 10mA
• Designed to allow the user to test both auxiliary
earth and probe resistances
• Displays the actual test current to further en-
hance and control measurement quality
• Probe and auxiliary ground resistance up to 50
kΩ
• Disturbance voltage detection
• Two measurement frequencies for disturbance
voltage suppression
• Automatically optimised measurement frequen-
cy selection
• Pre-selection of maximum admissible contact
voltage: UL 25/50 V
20
• Large, visible display
• Energy management
• Built in accordance with IEC1557-5, EN61557-
5,DIN VDE 0413 Part 7
Scope of Supply:
1 pce TELARIS EARTH Order No. 8986
1 pce test lead, black
1 pce test lead, blue
1 pce alligator clamps, black
1 pce alligator clamps, blue
1 pce carrying holster
6 pcs batteries 1.5V Mignon LR6 Size AA
1 pce instruction manual

2.0 Transport and Storage

Please keep the original packaging for later trans-
port, e.g. for calibration. Any transport damage due
to faulty packaging will be excluded from warranty
claims.
In order to avoid instrument damage, it is advised
to remove batteries when not using the instrument
over a certain time period. However, should the in-
strument be contaminated by leaking battery cells,
you are kindly requested to return it to the factory
for cleaning and inspection.
Instruments must be stored in dry and closed areas.
In the case of an instrument being transported in ex-
treme temperatures, a recovery time of at least 2
hours is required prior to instrument operation.