Your Internet Cable Is Not Plugged In Message; Cannot Access Your Router Message - Linksys XAC1200 Guide De L'utilisateur

Linksys XAC-Series Linksys XAC-Series
Your Internet cable is not plugged in
message
If you get a "Your Internet cable is not plugged in" message when trying to set
up your router, follow these troubleshooting steps.
To fix the problem, try the following:
1. Make sure that the Ethernet cable of the APM103 ADSL2+ Power Modem
is securely connected to the yellow Internet port on the back of the router.
1.
Back view of router
APM103 ADSL2+ Power Modem
Ethernet Cable
2. Make sure that your APM103 ADSL2+ Power Modem is connected to
power and the DSL phone line.
3. Install the router again.

Cannot access your router message

If you cannot access your router because your computer is not connected to
your network, follow these troubleshooting steps.
To access your router, you must be connected to your own network. If you
currently have wireless Internet access, the problem may be that you have
accidentally connected to a different wireless network.
To fix the problem on Windows computers, do the following:
1. On your Windows desktop, right-click the wireless icon in the system tray.
The icon might differ depending on your version of Windows.
2. Click View Available Wireless Networks. A list of available networks will
appear.
3. Click your own network name, and click Connect. In the example below,
the computer was connected to another wireless network named
JimsRouter. The name of the Linksys E-Series network, BronzeEagle in this
example, is shown selected.
Troubleshooting
10 10