MCS Master BCF 230RB Manuel D'utilisation Et De Maintenance page 9

on the nameplate, using cables of
suitable section (the supply voltage
must not vary more than ± 5% from
the value stated on the nameplate).
►1.12. Make sure that the cooler is
earthed properly.
►1.13. Make sure that during the
electrical connection, the phase-
neutral connection is complied
with. We recommend using a 2P
10A differential switch.
►1.14. The cooler can withstand a
maximum water inlet pressure of
3 Bar. If the pressure of the water
supply is higher, a pressure reducer
must be installed.
►1.15. Only fill the cooler tank only
with clean water.
►1.16. We recommend
horizontal coverage to protect from
weathering, in order to preserve the
cooler over time.
►1.17. It is forbidden to alter, tamper
with or adjust the cooler and the
electricity or water supply after
installation, if it is not carried out by
qualified personnel.
►1.18. Do not obstruct, even partially,
the air vents of the cooler, in order
to prevent a hazard.
►1.19. In order to prevent serious
damage, do not let dust, dirt or other
materials come into contact with the
cooler.
►1.20. We recommend using the
cooler with ambient temperatures
between 18°C and 45°C and with
water temperature below 45°C.
►1.21. In order to prevent serious
breakdowns, when the temperatures
drop to about <2°C, completely
empty the tank and the pipes that
supply water to the cooler.
►1.22. Disconnect the power supply
when you handle or service the
cooler (use personal protective
Figures and texts of this book are protected by COPYRIGHT.
equipment in order to prevent any
hazards).
►1.23. If the power supply cable is
damaged, it must be replaced by a
technical support centre to prevent
any risk.
►1.24. Protect the power cable from
potential damage caused by the
movement of vehicles, pedestrians,
weathering and heat sources.
►1.25. In the event of the cooler
malfunctions, disconnect the power
supply and contact the technical
support centre.
►1.26. Unplug the cooler from the
power supply, when it is not used
for a medium to long term period.
►1.27.
using frequently in order to prevent water
stagnation.
►►2. UNPACKING
(Pic. 1)
IMPORTANT:
FORBIDDEN TO STACK TWO OR
MORE APPLIANCES.
►2.1. Remove all packaging materials
used to wrap and deliver the appliance
and dispose of them in compliance
with the Standards in force.
►2.2. Extract all articles from the
packaging.
►2.3. Check for any damage undergone
during transport. Immediately inform
the dealer where the appliance was
purchased if this appears damaged.
Empty the cooler
IT IS
en
tank
STRICTLY