Heco Ascada 600 TOWER Mode D'emploi page 12

(3) LED display:
The 2-digit display shows the selected input - information about the operating status
• Inputs:
BT: Bluetooth input - The display flashes while the connection is being established / in pairing mode.
OP: Optical digital input
CO: Coaxial digital input
UB: USB audio input
AX: Analogue input
• Volume display: When changing the volume, the current value (0 ... 40) is displayed. If the playback is muted (mute),
the current value flashes.
• TD: The right (master) speaker could not establish a wireless connection with the left (slave) speaker.
• TC: The display flashes while the wireless audio connection is being established between the right and left speakers.
• The display goes out approx 10 seconds after the last operation.
(4) Remote control sensor: always point the remote control towards this point on the right (master) speaker.
RighT (mAsTER) spEAKER cOnTROls, TOp REAR (fig. 3)
(7) Rotary/push button for source selection and volume control. If the speakers are in standby mode, they can be
switched on via the push-button function.
(8) Controller to boost / reduce the bass level
(9) Controller to boost / reduce the treble level
RighT (mAsTER) spEAKER cOnTROls, BOTTOm REAR (fig. 4)
(10) Power switch
(11) Mains voltage selector switch
(12) Mains connection
(13) Fuse
(14) USB charging port
(15) Stereo USB input
(16) Optical digital input
(17) Coaxial digital input
(18) Stereo input Eingang (RCA jack)
(19) Output for connecting an active subwoofer
(20) Connection for the left speaker via the XLR cable supplied
(21) Pairing button for wireless connection left - right
lEfT (slAVE) spEAKER cOnTROls, fROnT (fig. 2)
(5) STBY/POWER:
• Red: Standby mode
• White: Operating mode
(6) Status display wireless connection right – left speaker:
• flashing slowly: Establishing connection
• permanently lit: Connection established
• off: No wireless connection, signal transmission via cable
lEfT (slAVE) spEAKER cOnTROls, BOTTOm REAR (fig. 5)
(22) Power switch
(23) Mains voltage selector switch
(24) Mains connection
(25) Fuse
(26) Connection for the right speaker via the XLR cable supplied
(27) Pairing button for wireless connection left - right
12