FISCHER Komfort Mode D'emploi page 11

Assembly
GB
86388-FIS-IM-V03-INT-OEF.indd 11
Fold out the back wall upwards and attach it on both
sides with the Velcro strip.
Press in the securing pin on the base frame and at
the same time push the mudguard over it (one on the
front, one on the rear). Make sure that the securing
pin is seated in the hole in the mudguard.
To close the trailer pull down the cover and secure
it on each side by means of the 3 Velcro closures.
Also attach the cover at the bottom end of the front Also attach the cover at the bottom end of the front
and rear. and rear.
Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures Velcro closures
Fit together the two parts of the pennant pole and
push it through the aperture in the cover into the
support on the left side.
Step 5
Folding out the back wall
Step 6
Attaching the mudguards
Step 7
Attaching the cover
Step 8
Attaching the pennant
07.01.16 10:22