Troubleshooting Checklist; Warranty - Terrier TNMK Mode D'emploi

10

TROUBLESHOOTING CHECKLIST

Failure/malfunction
Load slipping
Housing is deformed
Lifting shackle oval
Spring defective
Pins are bent or worn
Retainingpins are missing
Difficult to open/close clamp Clamp is worn
11

WARRANTY

Terrier Lifting Clamps provides a 5 year warranty on its lifting clamps. This warranty
is applicable to the original end user of the lifting clamps. Only if the clamp has been
inspected, checked and maintained by this instructions and by an official dealer. This
warranty period of 5 years is valid from the day of purchase, and is liable to all conditions
and measurements stated in this document.
11a CONDITIONS
This warranty only covers failures in the lifting tools which is the consequence of
production errors which occur during normal use. The warranty covers no wear to
components such as pivots, cam assemblies, lock springs etc. Should there be any kind
of failure within this guarantee period, the lifting tool will be replaced or repaired to
insight of the producer.
No warranty is given to clamps due to the following failures:
- Regular wear.
- Overload.
- Wrong and/or carelessly use.
- Damages.
- Not following procedures and measures.
- Hoisting differing material other then indicated on clamp or stated in the user-manual.
- Adapting and/or modifying of the Terrier clamp.
- The injudicious use of the clamp, and not succeeding all indications which are stated
in the users manual.
- When maintenance and/or revision has not been carried out by an authorised Terrier
distributor.
The producer is not responsible for incidental damage or damage due to wrong use of
the lifting tools as well as from violation of this manual.
Possible Cause
Load dirty
Lifting shackle and
chain deformed
Jaw is open and bent
Clamp is overloaded
Clamp is overloaded
Spring worn out
Clamp is overloaded
Incorrectly assembly
Clamp contaminated
Action
Clean load
Do not use clamp
Do not use clamp
Do not use clamp
Do not use clamp
Have clamp serviced
Do not use clamp
Mount new retaining pins
Do not use clamp
Clean clamp
13