Craftsman CMEF900 Guide D'utilisation page 7

OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: Shock hazard. Under no circumstances
should this product be used near water.

WARNING: Risk of lacerations or burns. Do not
touch workpiece or accessory immediately after
operating the tool. They can become very hot. Handle
carefully. Always allow accessories and workpiece to
cool before handling.
Proper Hand Position (Fig. C)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal injury,
ALWAYS hold securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the handle
Do not grasp the gear case with either hand during use.
Fig. C
3
Forward/Reverse Switch (Fig. D)
• Press the bottom part of the forward/reverse switch
marked "F" to run the tool in a forward (right‑hand
thread) direction.
• Pressing the top of the forward/reverse switch
marked "R" to reverse the motor direction.
Fig. D
1
Fastening

WARNING: Ensure fastener and/or system will
withstand the level of torque generated by the
tool. Excessive torque may cause breakage and
possible personal injury.
1. Place the accessory on the fastener head. Keep the tool
pointed straight at the fastener.
2. Press forward/reverse switch
Always check torque with a torque wrench, as the
fastening torque is affected by many factors including
the following:
Voltage: Low voltage, due to generator or long
extension cord, will reduce fastening torque.
Accessory size: Failure to use the correct accessory size
will cause a reduction in fastening torque.
Bolt size: Larger bolt diameters generally require
higher fastening torque. Fastening torque will also vary
according to length, grade, and torque coefficient.
Bolt: Ensure that all threads are free of rust and other
debris to allow proper fastening torque.
3 .
Material: The type of material and surface finish of the
material will affect fastening torque.
Fastening Time: Longer fastening time results in
increased fastening torque. Using a longer fastening
time than recommended could cause the fasteners to
be overstressed, stripped or damaged.
Capacity
Your 1/2" impact wrench uses sockets with 1/2" square
drive ends.
MAINTENANCE

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Accessories
1

WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
1
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
Versatrack™ (Fig. E)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: To reduce the risk of serious personal
injury, do not use a damaged Versatrack™ peg hook
English
1 to start operation.
5