HELVAR iDim 304 Manuel D'utilisation page 6

Mémoriser les scènes par la télécommande iDim
Pour mémoriser les niveaux dans la scène sélectionnée par la
télécommande.
1. Dirigez la télécommande vers un contrôleur
2. Appuyez pendant 10 sec. les boutons 1, 2, 3 ou 4.
Les LEDs iDim Sense clignoteront vert si réussite.
will then fl ash the iDim mode number red / green to signify that
the iDim Sense is in User Defi ned mode.
Note: Mode fl ash will only occur when storing scenes for the fi rst
time. Further scenes stores will only activate green
scene store LED.
To exit User Defi ned mode and reset the iDim Sense to default
mode settings, the iDim Remote Control must be in 'special
function mode'. Please see chapter below for more information.
Fonctions spéciales par la télécommande iDim
It is possible to make the iDim Remote perform advanced tasks to assist commissioning and system testing. The iDim Remote uses a 'special
function mode' where these advanced tasks can be confi gured. This mode must be activated before a special function or test is run. This avoids
accidental confi guration changes or tests being run which could cause the light levels or scenes to be altered unintentionally.
Please see below for activating and deactivating special function mode and overleaf (pages 7 - 8) for the types of special functions possible.
To activate special function mode:
1. Remove the battery cover from the remote control.
2. Using a pen (or other long blunt object) press mode selector
button on the reverse of the iDim Remote for 3 seconds.
Special function mode is now active.
3. Check that the iDim Remote is in special function mode by
recalling a scene. The iDim Remote LED will fl ash orange
when a function (i.e. Scene recall) is performed.
4. Run the special functions that you require. (See pages 7 and 8
for special functions)
Note 1: All standard operation settings such as scene recall, modify
and store scene are still possible when the iDim Remote is in
special function mode.
Note 2: Once special function mode is activated it will remain so until
it is manually deactivated.
To deactivate special function mode:
1. Hold the mode selector button for 1 second to return to
standard operation. Special function mode is now deactivated.
2. Check that the iDim Remote is in standard operating mode by
recalling a scene on the remote. The iDim Remote LED should
fl ash green when scene recall is called.
6
Doc No: 7860263
The iDim mode
Les données peuvent être modifi ées à tout moment et sans préavis. www.helvar.com
1
1 5
6
2
2
3 7
4 O
10 s
3
4
3 seconds
When a remote key is pressed during
standard operation iDim Remote LED
Ch1 Ch2
fl ashes green.
When a remote key is pressed in special
function mode iDim Remote LED fl ashes
Ch1 orange.
Ch2
When the iDim Remote is communicating
with a PC the iDim Remote LED fl ashes
Ch1 red. Do NOT disconnect during this time.
Ch2
iDim Sense Information de
retour LED
250 250
ms 250 ms 250
625 ms
ms ms
Mode 2 (Bureau
individuel)