nedis SPYCCL10CSR Mode D'emploi page 5

the button again. The red indicator flashes quickly 3 times
and stays on.
Photo function
1. Switch to on with the on/off switch. The indicator lights up
red.
Note: if the indicator does not light up, press the on/off button of the
remote control to turn it on.
2. Press the photo function button to make a photo. The red
indicator goes off after a few seconds and then returns red.
Press again for more photos.
Audio function
1. Switch to on with the on/off switch. The indicator lights up
red.
Note: if the indicator does not light up, press the on/off button of the
remote control to turn it on.
2. To record only audio, press the start/stop recording audio
button. The red indicator starts to flash slowly. Press again
to stop audio recording.
General
- When no function is activated within 1 minute, the power will
automatically shut down to save battery power.
- The video, photo and audio files are stored in the folder DCIM,
100 MEDIA. Connect the device to a computer or notebook
with the USB cable. Select in the window "open folder to view
files".
- When the battery power is low during use, the current file will
be saved before the device turns off.
- When the device does not power on, then the battery power
is probably low and needs to be charged again before use.
- When the Micro SD card is defective of not inserted, the red
indicator will flash for a few seconds and then automatically
turn off.
- Save your data when you connect to a computer otherwise
the data will be over-written when the SD card is full.
5
ENGLISH