TRENDnet TU3-S35 Guide D'installation Rapide page 8

Troubleshooting
1. My computer does not recognize the TU3-S35. What should I do?
1. Verify that the computer meets the minimum requirements as listed in section 1.
2. Make sure the power adapter is properly connected.
3. Try plugging the device into a different USB port on your computer.
2. How do I format my brand new hard drive with the TU3-S35?
1. For Windows 7/Vista, right click on Computer and select Manage. When the
Computer Management screen appears, click on Disk Management. Right
click on the hard drive and click New Simple Volume.
Follow the New Simple Volume Wizard and then click Finish.
2. For Windows XP, go to Start
Tools Computer Management
Convert Disk Wizard appears, click Cancel. Right click the Unknown drive,
click Initialize and then click OK. Right click on the unallocated region of the
hard drive and select New Partition. Follow the New Partition Wizard
instructions then click Finish. The hard drive will automatically start the
formatting process.
Note: Make sure that the selected hard drive is not your C or D drive. Also
make sure that the selected hard drive is connected to the TU3-S35.
3. My computer does not list any drives? What should I do?
1. Verify that the device is installed properly. On Windows 7/Vista, right click on
Computer, select Properties and then click Device Manager. Click on Disk
Drives and verify that USB 3.0 MassStorage USB Device is listed. On Windows
XP, right click on My Computer and select Properties. Click on Hardware and
then Device Manager. Double click on Disk Drives and verify that USB 3.0
MassStorage USB Device is listed.
2. If you are attaching a brand new hard drive, format the drive. Please refer to
question 2 for more information.
If you still encounter problems or have any questions regarding the TU3-S35, please
contact TRENDnet's Technical Support Department.
Settings Control Panel
Disk Management. If the Initialize and
6
Administrative