EINHELL PROFI Silver Line PS-AS 18/1H Mode D'emploi page 9

Anleitung PS-AS 18-1H_SPK1
only when the drill is at a standstill. If you fail to
observe this point, the gearing may become
damaged. When the slide switch is in the middle
position, the ON/OFF switch is blocked.
ON/OFF switch (4)
Infinitely variable speed control is possible with the
ON/OFF switch. The further you push the switch, the
higher the speed of the cordless screwdriver.
Screws
It is advisable to use self-centering screws (e.g. Torx,
cross recessed head) as these will enable you to
work safely and reliably. Always make sure that the
bit used is of the same size and shape as the screw.
Set the torque to suit the screw size as specified in
the instructions.
Special additional functions (Figure 4):
Battery swivel mechanism
To handle work in hard-to-reach areas the
battery pack can be swiveled through 360°.
Additional handle (9)
You can achieve a safe body posture for working
by turning the additional handle. Undo the screw
(a) on the additional handle and turn it. Then
tighten the screw (a) again.
Cleaning and maintenance
Important! Always remove the battery pack before
starting cleaning or maintenance work.
Clean the tool at regular intervals, ideally
immediately after you finish working with it.
Do not clean the tool with sharp objects.
No liquids may be allowed to ingress into the tool.
Use soap suds and a soft cloth to clean the casing.
Never use gasoline, solvent or cleaning products that
are aggressive to plastic.
The ventilation slots must be clear at all times.
20.08.2005 9:17 Uhr Seite 9
Technical data:
Motor supply voltage
Speed 0-500/0-1400 rpm
Torque
Clockwise/Counter-clockwise
Clamping range of drill chuck
Charge voltage for rechargeable battery
Charge current for rechargeable battery
Battery charger supply voltage
LPA noise level:
LWA noise level:
Weight:
Vibration: a
w
!
iNTERNATiONALES SERViCE CENTER GmbH
Batteries and cordless electric machines and tools
contain materials that are potentially harmful to the
environment. Never place any cordless electric machines
or tools in your household refuse. When cordless electric
machines or tools become defective or worn, remove the
batteries and return them to iSC GmbH (address:
Eschenstrasse 6, D-94405, Germany). If the batteries
cannot be removed, return the complete cordless
machine or tool. You can then be sure that the
equipment will be correctly disposed of by the
manufacturer.
GB
18 V =
17 settings
Yes
max. 13 mm
18 V =
2500 mA
230 V ~ 50 Hz
73 dB(A)
82 dB(A)
2.4 kg
< 2.5 m/s 2
9