Acoustic Research WHT24 Manuel D'installation Et D'opération page 13

2. Connect the transmitter to your component receiver using either the speaker wire
or RCA pre-output connections, being careful to match the wire colors.
FIGURE 8 - Connect Transmitter with Speaker Wires
FIGURE 9 - Connect Transmitter with RCA Cables
NOTE: Use RCA cables only when surround rear pre-outputs are available.
Do not use with fixed-level RCA outputs.
LEFT RIGHT
REAR REAR
LEFT RIGHT
Power
6.3VAC R Audio In L
on/off
+
Power
6.3VAC R Audio In L
on/off
+
page 11
HDMI
IN
LEFT RIGHT iPOD IN
SURROUND SURROUND CENTER
IF
LFE OUT
MONITOR
Speaker
/RCA
Link
Speaker
R Audio In L
/RCA
Speaker
/RCA
Link
Speaker
R Audio In L
/RCA
WHT24
OUT