Installing Your Beverage And Wine Center; Unpacking Your Beverage And Wine Center; Leveling Your Beverage And Wine Center; Proper Air Circulation - RCA RFMIS1530 Manuel De L'utilisateur

English
Installing Your Beverage And
Wine Center

Unpacking Your Beverage And Wine Center

1. Remove all packaging material. This includes the foam base and all
adhesive tape holding the beverage and wine center accessories
inside and outside.
2. Inspect and remove any remaining packing, tape or printed
materials before powering on the beverage and wine center.

Leveling Your Beverage And Wine Center

• Your beverage and wine center has two leveling legs which are
located in the front corners. After properly placing your beverage
and wine center in its final position, you can level your beverage
and wine center.
• Leveling legs can be adjusted by turning them clockwise to lower your
beverage and wine center or by turning them counterclockwise to
raise your beverage and wine center. The beverage and wine center
door will close more easily when the two front leveling legs are
extended slightly.

Proper Air Circulation

• To ensure that your beverage and wine center works at the
maximum efficiency it was designed for, you should install it in a
location where there is proper air circulation and electrical connections.
• The following are recommended clearances around the beverage
center:
Sides...............2" (50mm)
Top....................2" (50mm)
Back..................2" (50mm)
• Do not over fill your beverage and wine center for proper cooling.
Note: If your beverage and wine center has been tilted for any reason,
Drip Tray
• Ensure the drip tray in the rear of the unit is in the proper position.
3
wait 24 hours before plugging it in.